Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 189

Hydraulic Pump Belt
The Hydraulic Pump Belt (located on the front
left hand side of the engine) uses a spring
tensioner which requires inspection at regular
service intervals.
If the tensioner loses tension, belt slip will
occur and the tensioner must be replaced.
Check the belt regularly, as it may become
slippery, frayed or cracked over time. In
addition, belt ribs will turn red when worn and
in need of replacement.
GA8701177 REV 2 APRIL 2022
Use a breaker bar with a 1/2" socket to release the
hydraulic pump belt tensioner.
To Replace the Hydraulic Pump Belt:
1 Remove the drive belt using a breaker bar
with a 1/2" square drive to release the
tensioner before slipping the belt off.
Slowly & smoothly release bar to avoid
snap back injury.
2 Replace the drive belt using the breaker
bar with a 1/2" square drive to release the
tensioner.
Slip new belt on & ensure the belt ribs are
aligned correctly with the pulleys.
Slowly & smoothly release bar to avoid
snap back injury.
Lubrication & Maintenance – Service
Cabin Air Cleaner on the rear right hand side of the cabin.
Cabin Air Cleaner
The Cabin Air Cleaner is externally located at
the rear right hand side of the cabin.
The filter cleans impurities from air entering
the cabin. Air is drawn in through the carbon
filter by a fan which pressurises the cabin
preventing impure air entering the cab from
gaps or possible seal leaks.
Filter elements include a:
• Pre-cleaner &
• Carbon filter.
The Pre-cleaner is a foam element which must
be cleaned regularly.
The Carbon filter must be checked regularly
and changed when necessary.
Carbon balls within the Carbon filter capture
air impurities from the air passing through the
filter.
A colour indicator on the end of the filter
shows when the filter needs replacment (or
recharging by a certified agent).
Unscew the carbon filter retaining nut & remove the filter
element from the filter housing.
To Service the Cabin Air Filter:
Carbon Filter
1 Unscrew the top housing retaining band.
2 Remove the top of the housing.
3 Unscrew the carbon filter retaining wing
nut
5 Remove the filter element from the
housing.
6 Check the carbon ball colour guide:
• Purple - Active
• Brownish Orange - Active
• Brownish Red - Filter must be replaced
(or recharged by a certified agent).
When the indicator shows Brownish Red,
replace/renew the carbon filter.
Carbon Filter specification is provided in the 'Service Parts'
& 'Filters' section in this chapter.
8
189