Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 190

Service – Lubrication & Maintenance
8
7 Fit the filter element into the housing.
8 Refit the filter retaining wing nut & tighten.
9 Refit the top of the housing & retaining
band and tighten the band.
Refer to Fillter specification provided in the
'Maintenance Schedules' of this chapter.
Foam Element
Clean the grey foam element of the Cabin Air
Cleaner regularly.
190
Allison 6 Speed Automatic Transmission.
Transmission
The Allison 6 Speed Automatic Transmission
oil level must be checked regularly.
Follow the transmission oil & oil filter service
schedules specified in the 'Maintenance
Schedules' of this chapter.
Check the transmission oil level using the
dipstick located on the left hand side in front
of the cabin. Oil level must be checked with
the engine running.
If oil is cold (less than 70 degrees Celsius)
the oil level must be in the lower range on the
dipstick.
If oil temperature is warm (above 70 degrees
Celsius) the oil level must be in the upper
range on the dipstick.
Avoid any skin contact with used transmission oil.
Beware that draining transmission oil may be hot.
Failure to follow these cautions may result in personal
injuries.
Transmission oil dipstick.
To Replace the Transmission Oil:
1 Park the Cruiser on a flat level surface.
2 Place a suitable container under the
transmission to collect draining oil.
3 Remove the drain plug from the bottom
of transmission oil pan. Warm oil will drain
more easily.
4 Remove & replace the transmission oil filter
according to the following instructions.
5 Allow the oil to drain out fully, then re-fit the
drain plug & sealing washer. Tighten drain
plug to 30-40 Nm (22-30 lb ft)
6 Refill the transmission with fresh oil via the
dip stick tube (located on the left hand
side in front of the cabin) until the oil level
on the dipstick is correct.
7 Start the engine. The oil level will drop
as it fills the oil lines running from the
transmission.
7 Top up the oil level until it again reads
correctly on the dip stick.
8 Replace the dipstick & stop the engine.
The oil filter & magnet is located on the bottom left hand side
of the transmission.
To Replace the Transmission Filter:
1 Remove the spin-on external filter by
rotating it in the counter-clockwise
direction. A standard strap-type wrench
may be used.
2 Remove the magnet from the filter
attachment tube or the top of the filter
element.
3 Clean any metal debris from the magnet.
Any metal pieces found larger than dust
needs to be further investigated.
4 Re-install the magnet onto the filter
attachment tube.
5 Lubricate the gasket on the filter with a
thin film of transmission fluid.
Transmission Maintenance Schedules and transmission
fluid specification can be found the 'Maintenance
Schedules' of this chapter.
GA8701177 REV 2 APRIL 2022