Wheel Camber; Wheel Nut Tension - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Wheel Camber

Wheel Camber is factory set and cannot
be adjusted. At the time of manufacture the
wheel camber is set to +1.0º.
GA8701177 REV 2 APRIL 2022
Recommended
pressure at
Size & Load
Index
30km/h 50km/h
kPa / PSI kPa / PSI
480/80R46
240 / 35 290 / 42
166A8/159D
480/80R50
220 / 32 240 / 35
177A8/166D
520/85R46
220 / 32 240 / 35
173A8/169D
Cruiser tyre options & recommended tyre pressures.
Tyre Maintenance
The Cruiser has three tyre options (see above).
It is very important that tyres are properly
maintained.
Tyre pressure is the most important factor
for maintaining correct load rating of the tyre.
Correct tyre pressure should be maintained at
all times.
Tyre pressure should be checked regularly -
every 8 to 12 hours of operation.
Inflation above or below recommended
pressures may cause damage to the tyres.
High road speeds & heavy loads may cause
tyres to wear prematurely.
Do not chock or support the machine using materials that
may crumble.
Use only load rated supports.
Lubrication & Maintenance – Service
Regularly check tyre pressure and wheel nut tension.
If a tyre is replaced with a different brand or
size, please contact the supplier for correct air
pressures to suit the load carrying capacity of
the Cruiser.
Protect the tyres as much as possible to
minimise wear and deterioration. Chemical
sprays & insecticides are harmful to the
rubber in the tyres and should be washed off
immediately after use.
Take extreme care when inflating tyres and use an
accurate inflation gauge when doing so.
If tyres are inflated at a rapid rate then the tyre rim
combination may explode. This can result in serious or
fatal injuries.
1
6
7
10
3
4
9
8
5
2
Follow the wheel nut tightening sequence (above) to ensure
even wheel nut torque distribution (320 ft/lb).

Wheel Nut Tension

Wheel nuts must be tensioned daily when the
machine is new and whenever wheel nuts are
removed and refitted.
Once wheel nuts hold their tension, inspection
can be lengthened to approximately 50 hours.
Wheel nut tension specification on the Cruiser
front & rear wheels is 350 ft/lb.
Follow the wheel nut tightening sequence
(shown above) to ensure even wheel nut
torque distribution.
8
195