Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 230

Fast Tracking Problems – Trouble Shooting
9
If the SERVICE indicator is illuminated, then a fault in the
shift by wire system has occurred.
Transmission Shifter
Transmission Fault Warning
If the SERVICE indicator is illuminated, then a
fault in the shift by wire system has occurred.
A qualified technician should inspect the
system as soon as possible.
Operating the machine with the wrench icon flashing is
not recommended. It may indicate a loss of safety back
up systems. The operator should use extra caution when
shifting to ensure that the transmission is performing
properly.
230
When the tranmission shifter displays 'D-\-' (loss of J1939),
press 'D" and/or consult a qualified technician.
Loss of J1939
Loss of the J1939 to or from the shifter will
result in an error indicated on the display as
'D-\-'.
The SELECT display works as normal except
that in drive, only the error 'D-\-' is displayed.
Up shift and down shift commands are sent
on the J1939 link and can not function in this
mode.
The vehicle transmission will not be able to
hold any of the forward gears unless the loss
of J1939 occurred while a lower range than
currently selected. If this is the case, the
selected range will be the max range.
Press 'D' (Drive) during this situation to enable
shifting to all 6 gears.
If loss of J1939 occurs, consult a qualified
technician.
The 'Select' display flashes if restricted transmission shifting
occurs. If so, consult a qualified technician.
Range Inhibit Indicator
Certain conditions may cause the Allison
transmission control module (TCM) to restrict
shifting.
The range inhibit indicator alerts the operator
that such a condition exists when the
'SELECT' display (the left digit) begins flashing
& the 'MONITOR' Display (the right digit)
remains constant.
Please consult a qualified technician in this
situation.
Air conditioner display showing '01' HVAC Fault Code.
Air Conditioner Fault Codes
The overhead display of Air Conditioner in the
cabin may show one of the following HVAC
Fault Codes if a problem occurs:
01 HVAC High Pressure fault
02 HVAC Low Pressure fault
03 HVAC Control Panel Blower
Potentiometer fault
04 HVAC Control Panel Temperature
Potentiometer fault
07 HVAC Cab Temperature Sensor fault
08 HVAC Evaporator Sensor fault
09 HVAC Outlet Temperature Sensor fault
19 HVAC Communication fault.
GA8701177 REV 2 APRIL 2022