Fenceline Nozzles; Gps Autosteer On/Off; Cruise Control - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Press the L end of the Fence Nozzle push button to Start the
left Fenceline nozzle spraying. Press again to Stop spraying.

Fenceline Nozzles

The Fence Nozzle L/R push button ends are
used to individually switch On or Off the Left &
Right Fenceline Nozzles.
To Switch On/Off the Left Fence Nozzle:
i) Press the L end of the Fence Nozzle
push button to Start spraying from the left
Fenceline nozzle.
When the Fenceline nozzle is spraying, a
red LED light on the left hand boom tip
is illuminated & the G-Hub main screen
fenceline emblem lights Green.
ii) Press the L end of the Fence Nozzle
push button to Stop spraying from the left
Fenceline nozzle.
Boom Section 1 must be On and spraying for the left hand
Fenceline nozzle to operate.
GA8701177 REV 2 APRIL 2022
Press the R end of the Fence Nozzle push button to Start the
right Fenceline nozzle spraying. Press again to Stop spraying.
To Switch On/Off the Right Fence Nozzle:
i) Press the R end of the Fence Nozzle push
button to Start spraying from the right
Fenceline nozzle.
When the Fenceline nozzle is spraying, a
red LED light on the right hand boom tip
is illuminated & the G-Hub main screen
fenceline emblem lights Green.
ii) Press the R end of the Fence Nozzle push
button to Stop spraying from the right
Fenceline nozzle.
Boom Section 16 must be On and spraying for the right
hand Fenceline nozzle to operate.
Operation – Ready to Spray
Press the Auto push button to engage the Autosteer (if fitted).
Press the Auto push button to disengage the Autosteer.

GPS Autosteer On/Off

Autosteer is retrofitted by the dealer/customer
accoding to their requirements.
The black AUTO push button cycles the GPS
Autosteer ON/OFF.
To engage/disengage Autosteer (if fitted):
i) Press to Auto push button to activate the
Autosteer.
ii) Press to Auto push button to deactivate
the Autosteer.
The Autosteer function must be wired in or use CAN
communications for the Autosteer to operate.
The G-Hub Controller main screen displays the Cruise
Control mode & status.

Cruise Control

The Joystick is used in conjuction with the
G-Hub system choice of operating in one of
three Cruise Control modes:
• Classic
• Variable or
• Two Speed.
Three Joystick push buttons used with the
G-Hub Cruise Control are:
• Cruise Set/Decrease
• Cruise Resume/Increase
• Cruise Cancel.
6
117