Cruise Control Modes; Cruise Set/Decrease - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Ready to Spray – Operation
6
Variable Cruise selection.

Cruise Control Modes

Only one Cruise Control Mode can operate at
any given time. The Mode can be changed in
the settings menu on the G-Hub Controller.
The 'Cruise Master' must first be activated &
the Cruise mode is displayed on the screen.
Classic Cruise Control Mode
The Classic Cruise Control Mode allows the
operator to simply accelerate to a desired
speed, then Press the 'Cruise Set' push
button on the Joysti to set the speed.
The Cruise speed can be cancelled and resumed
at any time. Joystick movement is not active.
Classic Cruise selection.
118
Variable Cruise Control Mode allows the operator to move
the Joystick (Fore & Aft) for infinite speed variation.
Variable Cruise Control Mode
Variable Cruise Control Mode allows the
operator to set a High speed (for spraying) & a
Low speed (for headlands), and then, to move
the Joystick (Fore & Aft) for infinite variation of
speed between the settings.
The Low speed is pre-set.
The High speed is set using the 'Cruise Set'
push button when the joystick is pushed all
the way forward.
Variable Cruise Control Mode mode can be
used in combination with 3rd Gear pre-select
function which holds the transmission in 3rd
gear.
The Pre-Select 3rd Gear is activated by
pressing the 'Mode' push button on the
Transmission Controller'.
Dual Speed Cruise selection.
Two Speed Cruise Control Mode
Two Speed Cruise Mode functions similarly
to Variable Mode except the Cruiser is either
operating at the low or the high speed.
There is no variable speed setting in between
high and low speed settings:
• Push the Joystick Forward (usually
over centre) for high speed.
• Pull the Joystick Back (usually over
centre) for low speed.
Press the 'Mode' push button to engage the Pre-Select
Press the lower Cruise Set/Decrease push button to set the
current ground speed for Cruise Control & once set, press
the push button again to decrease set ground speed.

Cruise Set/Decrease

The Cruise Set/Decrease push button is used
to set the current ground speed as Cruise
Control Speed and to decrease the set ground
speed.
To Set/Decrease Cruise Control Speed:
i) The Cruise Indicator on the G-Hub Touch
Screen must be active (Blue or Green) to
enable use of the Cruise Set/Decrease
push button & the Foot Brake must be
released.
Press the Cruise Master switch on the
console to change the Cruise Indicator
on the G-Hub Touch Screen from Grey to
Blue.
The Cruise Cancel push button can be
used to cycle the Cruise Control between
On [active] and Off [inactive].
ii) Press the Cruise Set/Decrease push
button to set the current ground speed as
the Cruise Control Speed.
iii) Once the Cruise Control Speed is set/
engaged, press the Cruise Set/Decrease
push button down to decrease the set
ground speed.
To disable Cruise Control, press the Cruise
Cancel push button or apply the Foot Brake
which also cancels the Cruise Control.
GA8701177 REV 2 APRIL 2022