Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 145

Connect a 3" fill hose to the 'Clean Fill' inlet & Open the 'Clean Fill' ball valves.
5 Open the 'Clean Fill' ball valves (Cruiser & suction hose) by
moving the handles down (refer to 'Tank Filling' instructions
in this chapter).
6 Open the storage cabinet of the Quick Filling Station to
access the External G-Hub Controller.
7 Press the Screen Selector push button to select the 'Fill'
screen.
8 Fill the Product Tank with about 200 litres of clean water
(refer to 'Tank Filling' instructions in this chapter).
9 Fill the Rinse Tank full of clean water (refer to 'Tank Filling'
instructions in this chapter).
10 Press the Screen Selector push button to select the 'Clean'
screen.
It is important not not close the 'Clean Fill' valve while the pump is running.
Running the pump with a closed suction inlet may damage the pump.
GA8701177 REV 2 APRIL 2022
For Basic Rinse, individually, use each Rinse function in the left hand column of
the 'Clean' screen using the Select & Start/Stop push buttons.
11 Press 'Pump Rinse' push button On.
12 Process each Rinse function of the left hand list on the
External Controller 'Clean' screen:
• Pressure Filter
• RapidFlow
• Bypass Valve
• Agitator
• Deadhead Pump (diaphragm pump only).
Individually using the push buttons to:
• Select
• Start - allowing each function suitable time to rinse
thoroughly, then
• Stop the function.
Several functions can be started & running together but
then stopped individually with the Start/Stop push button.
If filling the Rinse Tank at the same time as the Product Tank, the 'Fill Rinse Tank'
push button will flash to indicate pausing until the Product Tank reaches 500 litre
level. Rinse Tank filling will then resume as indicated by a solid colour of the push
button. Individual tank filling rate is reduced when filling both tanks at the same
time.
Operation – Ready to Spray
G-Hub Home screen showing the Agitator, RapidFlow, RPM Raise, Master Switch
and Fenceline nozzles On for rinsing nozzles & boom lines.
13 Keep the 'Pump Rinse' touch button On & press the
'RapidFlow' touch button on the G-Hub Main screen to On
and proceed to rinse the boom and nozzles.
14 Open the spray gauge valve to flush out chemical, then
Close the valve.
15 On completion of the boom rinse, press the 'RapidFlow'
and 'Pump Rinse' touch buttons to Off.
16 Open the Product Tank drain valve & completely drain the
tank. Close the valve when empty.
17 Clean the suction & pressure filters.
18 Store & shut-down the Cruiser as required.
6
145