Engine - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Preparation for Use – Setting Up
4
Press the Engine Tab touch button to open the 'Engine' tab screen & the
'Diagnostic' tab screen appears.

5 Engine

Press the Engine Tab touch button to open the Engine tab
screen and the Engine tab screen opens displaying a series of
tabs (opening on the Diagnostic tab screen):
A. Diagnostics
B. Cruise
C. RPM
D. Engine Faults
E. Transmission Faults.
Pre-setting is required in B, C & D tab screens.
A. Diagnostics Tab
There is no pre-setting required in the Diagnostics tab
screen.
The Diagnostics tab displays serial numbers & useful engine
performance & trip information:
• Engine Serial No
• Engine Software Version
• Transmission Serial No
• Transmission Software Version,
84
Press the appropriate 'Reset' touch button to reset values back to zero at the end
of each trip.
and LIVE engine operating data:
i) Boost (bar)
ii) Instant Fuel Rate (l/hr)
iii) Average Fuel Rate (l/hr)
iv) Total Fuel Used (L)
v) Oil Pressure (bar)
vi) Coolant Level (L)
vii) % Load
viii) Trip Fuel (l/hr)
ix) Trip (hrs)
x) Trip Dist (km)
xi) Trip Engine (hrs).
Each Trip Information Display - items vii) to x) [Trip Fuel litres/
hour, Trip hours, Trip Dist kilometres & Trip Engine hours] has a
'Reset' touch button to reset values back to zero.
To set 'Trip' values back to zero, press the appropriate Reset'
touch button.
Press the Cruise Tab touch button to open the Cruise tab screen.
B. Cruise Tab
Press the Cruise Tab touch button to open the Cruise tab
screen and the Cruise tab screen opens displaying the Cruise
Control functions:
i) Headland Speed (kph)
ii) Accel Rate (sec)
iii) Decel Rate (sec)
iv) Enable Variable Cruise Control
v) 2 Speed Only Cruise
vi) Enable Overdrive.
GA8701177 REV 2 APRIL 2022