Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 141

Connect a pressure hose to the 'Fill Pump Aux Valve' 1'
camlock fitting.
3 Connect a pressure hose to the 'Fill Pump
Aux Valve' 1" camlock fitting (hose not
supplied).
4 Rotate the 'Fill Pump Aux' valve to On
position.
Ensure the 'Fill Pump Aux' valve is closed before
connecting or disconnecting the pressure hose.
Rotate the 'Fill Pump Aux' valve to On position.
GA8701177 REV 2 APRIL 2022
Press the 'Fill Pump' push button to pumping clean water.
5 With the Cruiser engine running at low idle,
press the 'Fill Pump' push button to On to
start pumping clean water.
6 Proceed to use the pressure hose for your
auxilliary cleaning operations.
7 When cleaning is complete, press the 'Fill
Pump' to stop pumping clean water.
8 Close the 'Fill Pump Aux' valve &
disconnect the pressure hose and replace
the camlock plug.
9 Close the 'Clean Fill' ball valves (Cruiser &
suction hose) and disconnect the suction
hose from the camlock coupling.
Rotate the 'Fill Pump Aux' valve to Off position.
Operation – Ready to Spray
Close & lock shut the storage box of the Quick Filling
Station.
On completion of the filling and rinsing
functions:
• Ensure all fill and pressure hoses are
disconnected/packed away.
• Close & lock the storage box of the
Quick Filling Station.
• On returning to the cabin, deactivate
the External Controller.
On return to the cabin, deactivate the External Controller.
Press the 'Pump Product' push button On, then press the
'Agitator' push button On to keep chemicals mixed.
Product Tank Agitation
Product agitation can be controlled manually
or automatically through the G-Hub system.
For example, the agitator can be set for the
centre high pressure jet to automatically
switch off below certain tank level to reduce
chances of foaming with less water.
Check the agitator for efficiency because
agitator nozzles can block. Refer Chapter 8
'Lubrication & Maintenance' for details.
To Agitate While Stationary:
1 Add a minimum volume of 500 litres of
fresh water to the Product Tank
2 Add all chemicals. See instructions -
'Filling the Sprayer' & 'Adding Chemicals
to the Product Tank'.
3 Add remaining water as required.
4 Press the 'Pump Product' push button On
to activate the spray pump, then press the
'Agitator' push button to On.
If a tank has been filled & spray mixture has settled, agitate
for as long as it takes to pump the total quantity of water in
the tank to remix the chemicals.
For example: For a tank with 6000 litres using a 250 L/min
pump, agitate for 6000 ÷ 250 = 15 minutes
6
141