Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 185

To open the bonnet unclip two latches, located on either
side of the bonnet near the cabin.
Opening the Engine Bonnet
To open the bonnet, unclip two latches
located on either side of the bonnet near the
cabin, then lift & move the bonnet forwards.
Don't let the bonnet fall forwards under it's
own weight.
Once opened, the bonnet remains open by its
over-centre weight.
When the bonnet is closed, ensure the latches are properly
attached and tight before driving the Cruiser.
GA8701177 REV 2 APRIL 2022
Left hand side bonnet latch unclipped.
Be sure to close the bonnet & refasten the
latches on both sides before driving the
Cruiser.
Strap tension can be adjusted, if necessary.
Ensure strap tension is tight when the bonnet
is closed.
Lubrication & Maintenance – Service
Crop Cruiser Front Headlights.
Headlights
To replace a globe, unclip the engine bonnet
latches on both sides of the bonnet, then lift
& move the bonnet forwards. Don't let the
bonnet rotate forwards under it's own weight.
Ensure the engine is cold, then lean across to
unclip the loom from the globe, then unclip the
globe from the headlight housing and remove
it.
If the engine has been running, take extra care around hot
engine parts such as the exhaust.
Allow the engine to cool down before doing maintenance
and repairs.
(A)
(B)
(C)
Align the headlight by adjusting three screws (A, B & C)
located around the headlight body.
Replace the globe with a new globe, then,
reconnect the loom.
Headlight alignment is made by adjusting
three screws located around the headlight
body.
Make a small adjustment to the screws, then
check to see if movement is in the correct
direction.
Repeat screw adjustments until the headlight
is properly aligned.
Ensure the bonnet is closed and latches re-
fastened before driving.
The headlight uses an HB3 globe type globe
(see details left).
Refer to Globe specification provided in
the 'Service Parts' of the 'Maintenance
Schedules' of this chapter.
8
185