Table of Contents
Advertisement
Preparation for Use – Setting Up
4
Lift up the the right hand rear latch of the armrest control
console.
Autosteer Installation
The Crop Cruiser is equipped to be fitted with
3rd party GPS Autosteer systems.
Inbuilt Autosteer connectors are located in
the Electrical Compartment located below the
armrest control console, as well as within the
roof space & top of the cabin.
Instructions here provide basic explanation for
accessing, locating and connecting relevant
connectors for Trimble & John Deere steering
systems.
Other systems may be used but detailes are
not provided here.
Refer to installation instructions in this chapter
for your chosen steering system.
While it is recommended to gain full access to the
electrical compartment via the right hand cabin door, it
should be noted that more limited access to the electrical
compartment can be made from within the cabin.
56
Lift & raise the front of the armrest control console to its
highest positon.
Accessing the Electrical
Compartment
It is recommended to open the right hand
cabin door and use a step ladder or a raised
platform to gain full access to the electrical
compartment.
To access the electrical compartment:
1 Start the engine and fully open the boom
to its working positon, then turn the front
wheels hard left to create space for a
ladder or platform to access the electrical
compartment. Stop the engine.
The right hand door latch in locked position.
The right hand door latch opened with the holding pin &
latch holding the door ajar.
2 While inside the cabin, lift up the right hand
rear latch of the armrest control console to
release the lock that holds the console in
its resting position.
3 Lift & raise the front of the armrest control
console upwards to its highest position.
4 Release the latch of the right hand door.
When accessing the electrical compartment using a ladder
from the outside, do not touch the engine exhaust pipe
(along the base of the cabin door) as it maybe very hot.
Failure to follow this instructions may result in injury.
The right hand cabin door fully opened.
Locking latches of the electrical compartment cover lifted
up to release the locks.
5 Unhook the door latch from the holding
pin, then fully open the right hand door.
6 Place the ladder or platform into positon to
safely access the electrical compartment.
7 Lift up the two latches locking the cover of
the electrical compartment.
8 Lift & remove the cover from the compartment.
Blue protective wrap covers many in-cab surfaces of a
new Crop Cruiser.
The blue protective wrap can be carefully removed when
desired.
An opened electrical compartment (cover removed).
GA8701177 REV 2 APRIL 2022
Advertisement
Chapters
Table of Contents
