Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 134

Ready to Spray – Operation
6
Press the 'RPM Raise & 'Pump Rinse' push buttons Off.
4 Disconnect the micromatic coupling from
the rinse socket and allow air to suck.
5 Rotate the 'Chemical Pump' valve to Off
position.
Rotate the Chemical Pump valve to Off position.
134
Rotate the Chemical Probe valve to Off position.
6 Rotate the Chemical Probe valve to Off
position.
7 Close the Rinse Coupling Valve.
Close the Rinse Coupling Valve, then disconnect the hose
from the Micromatic coupling on the Cruiser.
Disconnect the Micromatic hose from the Chemical Probe
Inlet & refit the camlock cap.
8 Disconnect the other end of the hose from
the 1" Chemical Probe Inlet & refit the
camlock cap.
9 Refer to instructions "To Add & Mix
Chemical in the Chemical Induction Hopper"
and "To Transfer Chemical from the
Hopper to the Product Tank") to complete
the hopper procedures.
Ensure the Rinse tank has a sufficient quantity of fresh
water before using the rinse functions.
Connect a Chemical Probe hose to the Chemical Probe
inlet.
To Add Liquid Chemical Directly to the
Product Tank Using the Chemical Probe
Inlet
The Chemical Probe Inlet can be used with a:
a) Chemical Probe, or
b) Micromatic fitting.
a) To Add Liquid Chemical to the Product
Tank Using the Chemical Probe
1 Connect a Chemical Probe hose to the 1"
Chemical Probe Inlet.
2 Connect the other end of hose to a
chemical source using the Chemical
Probe.
Do not let the 'Chemical Pump' run with a closed suction
inlet as it may damage the pump.
GA8701177 REV 2 APRIL 2022