Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 171

Make adjustment to the Boom Centre Level cable adjusters
as required.
To Adjust Cable Tension:
1 Follow the 'Before You Begin Making
Boom Adjustments' instruction.
2 Lower the boom to a suitable working
level.
3 Loosen the upper nut at each end of the
cable (each side).
4 Tighten the lower nuts on each end of the
cable to set the desired cable tension.
5 Tighten the nut firmly against the bracket
to hold its position.
GA8701177 REV 2 APRIL 2022
6 Now check the boom folds correctly.
Get someone to stand behind the sprayer
(out of the booms reach) and watch which
side the boom is tilting excessively down
when folding.
7 If necessary, unfold the boom and re-
adjust the cable tension to correct any tilt
problems.
8 Repeat steps 2 - 5 until the boom is level
when folding.
Boom Settings – Service
Ensure boom Protection Brackets are positioned correctly.
Boom Protection Brackets
Stainless steel boom protectors are fitted on
the boom to protect it when resting on the
boom rests for transport.
It is important to ensure that the boom
protection brackets are positioned correctly.
7
171