Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 67

Press the Next touch button.
13 Press the 'Number of Products' touch
button and a drop down menu appears.
Select & press the appropriate '1' product
and '1' appears in the Setup System
screen.
14 Press the 'Next' touch button and a
'Setup Application Type' screen appears.
15 Press the 'Application Mode' touch button
and a drop down menu appears.
Press the 'Application Mode' touch button.
GA8701177 REV 2 APRIL 2022
Select & press 'Tiered Boom - Low Side Drive'.
16 Select & press the 'Tiered Boom - Low
Side Drive' mode, and 'Tiered Boom -
Low Side Drive' appears in the Setup
Application Type screen.
17 Press the 'Next' touch button and a
'Setup Sections' screen appears.
18 Press the 'Number of Sections' touch
button and a drop down menu appears.
Setting Up – Preparation for Use
Press the 'Number of Sections' touch button. Leave the 'Equal
Widths Sections' blank. Press the Help Menu '?' touch button.
19 Select & press '16', then '16' appears in
the Setup Sections screen.
20 Leave the 'Equal Width Sections' box
unchecked (blank) as Goldacre booms are
plumbed with varying section widths.
21 Leave the 'Fence Rows Enable' box
unchecked (blank) as the Fence Rows are
enabled in the Goldacre G-Hub.
22 If more information is needed, press the Help
Menu '?' touch button and a Help menu
appears.
Select & press the Help Menu '?' touch button required. To
exit press the 'X' touch button.
23 Select & press the appropriate Help Menu
'?' touch button for more information on
settings. Another screen appears with
more informaton.
To exit the Help screen, press the 'X'
touch button & the screen returns to the
Setup Section.
24 Press the 'Next' touch button and a
'Setup Section Width' screen appears.
The easiest way to determine the Width of a Section is to
count the nozzles.
Start at section 1 which is on the left end of the boom by
counting the number of nozzles in the section.
For example, section 1 has 4 nozzles. Four nozzles at
500mm spacing gives a section width of 2.0m.
Repeat the procedure for each section.
This procedure is applicable to both Broadacre & Rowcrop
plumbed booms.
4
67