Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 132

Ready to Spray – Operation
6
Turn the Chemical Pump valve ON.
4 The air operated Chemical Pump requires
the Cruiser's engine to be running and
the pneumatic system to be pressurised
before use.
Activate engine 'RPM Raise' to maximise
pump performance.
132
Rotate the Chemical Probe valve to On position.
5 Rotate the Chemical Probe valve to On
position.
6 Place the Chemical Probe into the
chemical & Open the Probe Valve to
transfer the chemical to the Hopper.
Chemical will begin transfering to the
Hopper.
7 After the required amount of chemical has
been transfered to the hopper, pull the
Probe out out the drum to allow the pump
to suck air & purge all chemical mixture
out.
Place the Chemical Probe into the chemical & open the
Probe Valve to transfer chemical to the Hopper.
After the required amount of chemical has been transferred
to the Hopper, close the Probe Valve.
8 To rinse the Chemical Probe and hose,
place the Probe into a container of clean
water, then Open the Probe to suck clean
water through the Probe and hose.
On completion of rinsing, Close the Probe
Valve.
9 Then, rotate the Chemical Pump valve to
Off position.
Rotate the Chemical Pump valve to Off position.
Rotate the Chemical Probe valve to Off position.
10 Rotate the Chemical Probe valve to Off
position.
11 Disconnect the Chemical Probe hose from
the 1" Chemical Probe Inlet & replace the
camlock cap.
Disconnect the Micromatic hose from the Chemical Probe
Inlet & refit the camlock cap.
GA8701177 REV 2 APRIL 2022