Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 168

Service – Boom Settings
7
Press & hold the Boom Rest IN switch to lock down the LHS boom lock, then
press the Boom Fold IN switch momentarily to tighten the boom into its rests.
15 Press & hold down the IN end of the Boom Fold rocker
switch to fold-in the boom until it is close enough to the
boom rests to check the tilt alignment, then release the
switch.
Check & adjust the tilt angle on the RHS to raise or lower the boom to clear the
boom rest.
168
Press & hold the R Arrow Up or Down to adjust the boom to tilt on the right hand
boom end.
16 Check that the boom clears each of the boom rests:
• On the RHS & if adjustment is needed, press & hold the
R Arrow Up or Down part of the Boom Tilt push button
on the joystick. Release when the desired tilt is achieved.
• On the LHS & if adjustment is needed, press & hold the
L Arrow Up or Down part of the Boom Tilt push button
on the joystick. Release when the desired tilt is achieved.
Check & adjust the tilt angle on the LHS to raise or lower the boom to clear the
boom rest.
Press & hold the L Arrow Up or Down to adjust the boom to tilt on the right hand
boom end.
17 Once the boom are correctly adjusted for the boom rests,
press & hold down the OUT end of the Boom Fold rocker
switch to completely unfold the boom (until it aligns with the
boom centre section), then release the switch.
GA8701177 REV 2 APRIL 2022