Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 97

b) Enter Values for the 3TS Option
After nozzle selection, the 3TS configuration requires new
values to be entered into the controller according to the nozzles
selected, namely.
• Spray application rates
• Maximum flow rate (for each tier/nozzle fitted [2 tiers]).
To Enter New Application Rates:
Follow the steps 1 - 8 previously given under 'Enter Values for
the Single Line Boom'.
Tier Max Flow Rates
The Tier Max Flow Rates is the maximum boom flow rate that a tier will reach
before switching On the next tier.
GA8701177 REV 2 APRIL 2022
Calibration – Set & Check Application Rates
Press the 'Systems Settings' touch button.
To Enter Maximum Flow Rates:
1 Press the 'Systems Settings' touch button and the
'Systems Settings' screen appears.
2 Press the 'Tiered Boom Setup' touch button and the
'Tiered Boom Set-up' screen appears.
Press the 'Tiered Boom Setup' touch button.
Press the 'Tier 1 Max Flow Rate' touch button.
3 Press the 'Tier 1 Max Flow Rate' touch button and and a
numerical keypad appears.
4 Calculate Max Flow Rate of the 1st Tier nozzles fitted to the
boom, eg, AXIR110015 nozzle @ 5 Bar 0.761 l/min.
Multiply 0.76 x 72 (number of nozzles) = 54.7 l/min.
5 Press the 'X' touch button to clear the existing number and
press the touch buttons to enter the Max Flow Rate, eg,
54.7, then press the 'Tick' touch button.
The screen returns to the Tiered Boom Setup screen with
'54.7' in the Tier 1 Max Flow Rate value.
Press the appropriate touch buttons to enter the Max Flow Rate for Tier 1 (eg,
54.7 l/min), then press the 'Tick' touch button.
5
97