Installing John Deere Autosteer - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Optional Goldacres connecting cable (Part No.GA3000423)
for a Solsteer GPS Module.

Installing John Deere Autosteer

The John Deer Autosteer system requires
installation of three components:
• Solsteer GPS Module or Agra GPS
Bridge,
• Starfire GPS Receiver and
• Display console & harness.
To install the Autosteer Module:
1 Obtain the optional Goldacres JD
connecting cable (Part No. GA3000423)
for a Solsteer GPS Module.
2 Connect the Bridge connectors of the
Goldacres connecting cable & GPS Module.
Connect the bridge connectors of the connecting cable &
the GPS Module in the electrical compartment.
GA8701177 REV 2 APRIL 2022
Steering CAN connector in the electrical compartment.
3 Connect the Goldacres JD connecting
cable CAN connector to the Steering CAN
connector in the electrical compartment.
4 Connect the Goldacres JD connecting
cable SMARTRAX connector to the
SMARTRAX connector in the electrical
compartment.
SMARTRAX connector in the electrical compartment.
Setting Up – Preparation for Use
Remove the screws from the antenna connectors cover.
To Install the GPS Antenna:
The GPS Antenna connectors are located
within the roof space on the left hand side of
the cabin and the antenna platform is located
on the top of the cabin roof.
To access & fit antenna connectors:
1 Remove two screws from the front & rear
of antenna connectors cover above the
cabin door.
2 Remove the cover to access the antenna
connectors.
The cover removed showing the antenna connectors.
Optional Goldacres connecting cable (Part No.GA3000148)
for the Starefire Receiver.
4 Obtain the optional Goldacres connecting
cable (Part No. GA3000148) for a Starefire
Receiver.
3 Fit the connecting cable (GA3000148) to
the front connector in the cabin roof.
4 Feed the other end of the Starfire adaptor
cable through the front roof space to the
mounting plate on top of the cabin.
The Starfire adaptor cable fitted to the front connector.
4
63