Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 151

Open the Adjustable Axle Track valve on each of the 4
Adjustable Axle Tracks.
Adjustable Wheel Tracks
These instructions are only applicable to
Cruisers fitted with the Adjustable Wheel Track
option.
To Fully Extend or Fully Retract the
Adjustable Wheel Tracks:
1 Before entering the sprayer, manually
OPEN the valves on each adjustable axle
hydraulic cylinder (4 in total).
2 Start and drive the Cruiser as per the
instuctions in the 'Quick Start Guide' at
the beginning of this chapter.
3 Lock the transmission in 1st Gear to
achieve the best adjustment operation.
DO NOT attempt to extend or retract the axles while the
machine is stationary.
Failure to ensure the Cruiser travelling before extending or
retracting is attempted will create excessive pressure on
the wheel assembly & can cause damage.
GA8701177 REV 2 APRIL 2022
Press & Hold the Adjustable Axle Track In/Out Rocker
Switch (on the cabin corner panel) as required while
travelling forward at 10kph.
4 Maintain a constant speed of 10Km/h,
then Press & Hold the 'Axle In' or 'Axle
Out' rocker switch (located on the rear RH
Switch Panel below the ignition key).
5 Press & Hold the rocker switch until all 4
wheels have retracted or extended their
full travel In or Out.
6 Release rocker switch.
7 Manually CLOSE the valves on each
adjustable axle hydraulic cylinder (4 in
total).
Operation – Ready to Spray
To Extend or Retract the Adjustable
Wheel Tracks to a Desired Width:
1 Before entering the sprayer, manually
OPEN the valves on each adjustable axle
hydraulic cylinder (4 in total).
2 Start and drive the Cruiser as per the
instuctions in the 'Quick Start Guide' at
the beginning of this chapter.
3 Lock the transmission in 1st Gear to
achieve the best adjustment operation.
4 Maintain a constant speed of 10Km/h,
then Press & Hold the 'Axle In' or 'Axle
Out' rocker switch (located on the rear RH
Switch Panel below the ignition key).
5 Press & Hold the rocker switch until the
4 wheels have retracted or extended
the desired width In or Out, then release
rocker switch and stop the Cruiser.
When cleaning telescoping driveshafts and ONE wheel
is lifted OFF the ground, the adjustable axle can be
adjusted to the desired width providing the OTHER 3 axle
adjustment cylinder valves are CLOSED. Adjust & measure
the width and repeat the procedure for each wheel.
6 Measure the distance from the Cruiser
centre to the wheel centres to check the
required width, eg, 3.5m required width
= 1.75m from Cruiser centre to wheel
centre.
7 Close the cylinder valves of wheels that
meet the desired width.
8 Repeat steps 2 to 7 until all wheels are set
to the required width.
7 Check that all adjustable axle hydraulic
cylinder valves are fully CLOSED (4 in
total).
For extended road travel, the valves on each cylinder MUST
BE CLOSED to prevent unexpected axle movement.
Failure to ensure valves are fully closed for travelling
& operation may result in unexpected machine width
changes, instablity and unsafe operation.
6
151