Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 187

Open the heater ball valve (on the LHS rear of the engine)
when replacing coolant to bleed any air.
Coolant Replacement
Coolant must be replaced every 2000 hours.
Follow the instructions on top of the radiator.
Quantity & coolant type as shown in the
'Maintenance Schedules' of this chapter.
Ball valves (located on heater hoses on LHS
rear of the engine & header tank) may be
isolated during hotter weather to allow air
conditioning to operate more efficiently.
When replacing the coolant, these ball valves
must be opened so that all the air is bled from
the coolant lines.
Open the heater ball valve (on the top rear of the engine)
when replacing coolant to bleed any air.
GA8701177 REV 2 APRIL 2022
The Inline fuel filter located on the left hand side of the engine.
Fuel Filters
Three fuel filters are located on the left hand
side of the Cruiser engine area:
• In-line fuel filter, located on the left
hand side of the engine.
• Primary fuel filter with water separator
& manual hand pump, mounted on the
left hand chassis.
• Secondary fuel filter, locate on the left
hand side above the engine oil dip
stick (fine pressure filter).
The Primary fuel filter located on the left hand side of the
chassis.
Lubrication & Maintenance – Service
The Secondary fuel filter located on the left hand side above
the engine oil dip stick.
The Primary filter is the second point from the
fuel tank, it separates any water from the fuel
and also filters contaminants.
The water trap at the base of the filter cylinder
should be drained daily.
It has a sensor at its base which triggers an
alarm when excessive amounts of water are
detected in the fuel.
Unscrew & pump the plunger to prime the
fuel. Retighten the plunger after the fuel is
primed.
The Primary filter should be replaced within
the first 50 hours of use, then every 250 hours
of engine operation.
The Secondary (engine) filter is mounted on the
left hand side above the engine oil dip stick.
Refer to Fuel Fillter specification provided in
the 'Maintenance Schedules' of this chapter.
Required Fuel Filter maintenance is provided under 'Engine
Maintenance Shedules & Filter' specifications in this
chapter.
Engine oil dip stick (shown left [yellow]) & engine oil filler cap
(shown behind the dipstick).
Engine Oil & Filter
Follow the recommended service schedules
for engine oil and filter.
Check engine oil level DAILY.
To Check the Engine Oil:
1 Stop the engine.
2 Remove the engine oil dipstick from the
engine tube and wipe it clean of oil.
3 Replace the engine dipstick, then remove
it to measure the engine oil level.
The oil level must be between the 'ADD'
and 'FULL' marks on the dipstick.
If the oil level is below the 'ADD' mark, top-up
the oil level with the appropriate oil.
Refer to Lubricant specification provided in the
'Maintenance Schedules' of this chapter.
8
187