Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 224

Fast Tracking Problems – Trouble Shooting
9
Press the 'PLC I/O Out' Display tab touch button to display the PLC I/O Out
viii) PLC I/O Out
Press the 'PLC I/O Out' Display tab touch button to display the
screen.
The 'PLC I/O Out' screen provides checklists & readouts for
all Outputs to the Chassis Controller or Main Control Module
(located in the left hand side Fill Area toolbox).
• If an indicator displays Green it is On.
• If an indicator displays Grey, it is Off
• If an item displays Red, it is not working
If Red, go to the Chassis Controller or Main Control
Module and check the Output connections.
The number indicators shown on the PLC I/O Out screen above, namely:
• Spray Pump Drive '350' and
• Tank Fill Shut Off Vavle '650'
are the PWM outputs.
Numbers range from 0 to 1000 where 0 is Off & 1000 is fully On.
224
Press the 'Service' tab touch button which displays a Hardware tab screen, then
press the 'GA Fault Codes' Display tab touch button to display the screen.
GA Fault Codes
A further G-Hub 'Diagnostics' screen known as 'GA Fault
Codes' is available in the Service tab screen.
Press the 'Service' Display tab touch button, then press the
'GA Fault Codes' Display tab touch button to display the 'GA
Fault Codes' screen which gives current fault codes and their
descriptions.
Only active faults are displayed.
Once corrected the fault code automatically clears.
The ISOBus Module (also known as the Chassis Controller or Main Control
Module) located in the storage box of the Filling Station.
G-Hub Main PLC Controller
The G-Hub Main PLC Controller, also known as the Chassis
Controller or Main Control Module, is located in the storage box
of the Filling Station on the right hand side of the Cruiser.
Illustrations & a table (next page) provide trouble shooting touch
buttons & information for the light functions on the ISOBus
Module.
GA8701177 REV 2 APRIL 2022