Cabin Corner Panel; Carbon Filtration System - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Fully adjustable cabin overhead air flow vents for operator
comfort.
Setting Cab Temperature
The Temperature Display shows the currently
set temperature.
To Decrease the Temperature setting:
• Press the '- Decrease' touch button.
To Increase the Temperature setting:
• Press '+ Increase' touch button
Temperature will be adjusted in 1°C or 2°F
increments per touch button press, depending
on Display Unit selected (Refer to "Changing
Temperature Display" instructions next).
In Automatic Mode the air conditioner adjusts
the cab temperature to its set value. During
the Setting Cab Temperature procedure, the
fan speed may rise quickly so that the cab
temperature reaches the pre-set set point
more quickly, for example, on a very hot day.
When the cabin temperature approaches its
set value, the fan speed will reduce again.
GA8701177 REV 2 APRIL 2022
Ignition Key Switch
Aux USB Power Suppy
Cigarette Lighter
Adjustable Axle Track (3-4m) In/Out
Carbon Filtration Fan Rocker Switch
Glass Breaking Hammer
Changing Temperature Display
The Temperature Display can be changed
between degrees Celcius & degrees Farenheit.
To Change the Temperature Units:
• Press the '- Decrease' touch
button & '+ Increase' touch button
simultaneously for up to 3 seconds to
switch between units.
Repeating the above step will cycle between
the two units.
Displaying Outside Temperature
To display the Outside Temperature:
Press the 'Outside Temperature' touch button
and its Indicator lights illuminates. The display
now shows the outside temperature.
Adjusting Air Flow Vents
Air conditioner air flow is distributed inside the
cabin through fully adjustable airflow vents.
Each vent can be adjusted directionally or
turned On or Off to suit the individual needs of
For example, to heat the leg area, close all
upper vents and direct air flow of the lower
vents to the floor area.
Cabin – Your Sprayer at a Glance
12V
Sockets
12V Aux
Engine/Transmission
Power Supply
Diagnostic Connector
Connector

Cabin Corner Panel

The Cabin Corner Console (shown above) is
located in the right hand rear corner of the
cabin and incorporates the following:
• Ignition Key Switch
• Aux USB Power Supply
• Cigarette Lighter
• Adjustable Axle Track (3-4m) In/Out
• Carbon Filtration Fan Rocker Switch
• Glass Breaking Hammer (Emergency
use only)
• 12V Aux Power Supply Connector
• Engine/Transmission Diagnostic
Connector
• 12V Sockets.
Press the Carbon Filtration Fan Rocker Switch to activate
the Carbon Filtration System Fan before spraying.

Carbon Filtration System

A fan forced Carbon Filtration System in
conjunction with a fully sealed cabin creates a
pressurised operator environment preventing
contaminated air from entering the cabin.
The Carbon Filtration System removes dust,
pollen, fumes and other potentially harmful
pollutants from the air.
The Carbon Filtration fan (independent of
the air conditioner fan) must be switched On
separately for spraying operations.
To Activate the Carbon Filtration System
Fan:
• Press the Carbon Filtration Fan Rocker
Switch, located on the right hand side
Rear Corner Console (see above).
Carbon Filter Maintenance
Carbon filters require periodic maintenance.
See Chapter 8 'Lubrication & Maintenance' for
more information.
Both cabin doors (entrance door & emergency escape
door) must be completely closed and the Carbon Filtration
System must be running to protect the operator from
contaminated air.
3
41