Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 218

Fast Tracking Problems – Trouble Shooting
9
Trouble Shooting Preface
The following troubleshooting information is provided as a
reference if your machine is not functioning correctly.
To ensure that you receive the best possible service, it is
recommended that you exhaust all applicable troubleshooting
solutions shown in this chapter prior to calling your dealer, or
Goldacres for service advice
Parts information and schematics can be found in the parts
manual supplied.
218
Press the 'Settings' touch button, then the 'Diagnostics' tab touch button to
access the Diagnostics 'Network' screen.
Integrated G-hub System
Goldacres Integrated G-hub System offers full system
diagnostics, including warnings and operation states.
Pop up on-screen dialogs will display any system information
and warnings.
Some problems may simply be resolved by cycling the G-Hub
system off and on again.
It is recommended to try this first before resorting to more
advanced troubleshooting.
All valves will be reset to their initial position on the G-Hub
System start up.
The G-Hub 'Diagnostics' screens provide detailed information
on all system components.
Start with the Network Diagnostic page to make sure all CAN
components are online and operational, then move onto the
targeted area of the fault.
The CAN-link between the PLC and the main display are critical
for the system to function correctly.
If a CAN component has been replaced, it is important that the
correct software be uploaded and the correct CAN address is
set for it to function correctly.
The Diagnostics 'Network' screen showing all systems working except 'GPS'
which is not yet fitted.
The G-Hub 'Diagnostics' tab screen shows 8 tab touch button
screens with eight areas for trouble shooting:
i) Network
ii) G-Motion
iii) Console
iv) External Display
v) Troubleshooting
vi) Boom I/O
vii) PLC I/O In
viii) PLC I/O Out
i) Network
The Network display screens give a quick overview of the
whole G-Hub connectivity system:
• If an item displays Green it is connected & working.
• If an item displays Red, it is not connected or not
working.
Go to the next relevant G-Hub diagnostic page to
further check the item.
GA8701177 REV 2 APRIL 2022