Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 77

Press the Rapid Flow (Auto) function touch buttons to select or deselect them.
ii) Rapid Flow (Auto)
The Rapid Flow (Auto) settings (for boom recirculation) comprise:
• 'On When Sections Are Off' - automatically:
- Engages the Rapid Flow when selected boom
sections are turned Off
- Disengages Rapid Flow when boom sections are
turned On.
• 'Boom Master Auto Off' - automatically:
- Engages Rapid Flow when the Boom Master
Switch is used to stop spraying
- Disengages Rapid Flow when the Boom Master
Switch is used to start spraying.
To Select the 'On When Sections Are Off' setting:
Press the 'On When Sections Are Off' touch button. The
touch button displays Green when selected & Grey when
deselected,
OR
To Select the 'Boom Master Auto Off' setting:
Press the 'Boom Master Auto Off' touch button. The
touch button displays Green when selected & Grey when
deselected.
When setting the Rapid Flow (Auto) settings set the 'On When Sections Are Off'
OR the 'Boom Master Auto Off'. Select one or the other.
Both can be selected (Green) if desired.
GA8701177 REV 2 APRIL 2022
Press the Lower Tank Limit (L) display touch button to set the lower limit.
iii) Agitation Spray Mode (Auto)
The Agitation Spray Mode (Auto) function determines the
lower tank level that triggers the product tank agitator to stop
operating in order to reduce foaming at low tank levels.
To Set the 'Lower Tank Level (L)':
1 Press the 'Lower Tank Level (L)' display touch button
and a numerical keypad appears.
2 Press the numbers to set the value at 500, then press
'Enter'. The screen returns to the Agitation Spray Mode
(Auto) screen with 500 displayed in the 'Lower Tank
Level (L)' display.
The red valve at the base of the pressure filter must be open for back-flush
cleaning function to operate.
Setting Up – Preparation for Use
Press the Filter Clean (Auto) function touch buttons to select or deselect them.
iv) Clean Pressure Filter (Auto)
The Clean Pressure Filter (Auto) provides a back-flush cleaning
function to clean the pressure filter element. Select either:
• 'On When Sections Are Off' which automatically
engages the filter cleaning function when all booms
sections are turned off, or
• 'Boom Master Auto Off' which automatically engages
the filter cleaning function when the Boom Master
switch is switched Off.
To Select the 'On When Sections Are Off' setting:
Press the 'On When Sections Are Off' touch button. The
touch button displays Green when selected & Grey when
deselected,
OR
To Select the 'Boom Master Auto Off' setting:
Press the 'Boom Master Auto Off' touch button. The
touch button displays Green when selected & Grey when
deselected.
When setting the Clean Pressure Filter (Auto) settings set the 'On When Sections
Are Off' or the 'Boom Master Auto Off'. Select one or the other.
Both can be selected (Green) if desired.
4
77