Pre-Operation Check - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Ready to Spray – Operation
6
G6 Crop Cruiser Series 2
O P E R A T O R ' S M A N U A L M Y 2 0
GA8701177 REV 2
AUGUST 2021 - Draft 7
FROM SERIAL #203003
GA8701177 REV 2 AUG 2021 - Draft 7
G6 Crop Cruiser Operator's Manual.

Pre-Operation Check

Before Starting the Cruiser:
• Read the G6 Crop Cruiser Operator's
Manual thoroughly, before attempting
to use this machine
• Read & follow instructions on chemical
manufacturers labels
• Refer to instructions provided in other
operator manuals supplied
• Always wear appropriate protective
clothing.
• Before operating the machine, check
all fluid levels (oil, water & fuel).
• Check all maintenance procedures
have been followed
• Complete scheduled lubrication
A high quality multi-purpose grease is essential for the
machine to operate with maximum effectiveness and
life-expectancy.
It is important to keep the lubricant and lubricant applicator
clean. Wipe all dirt from the fittings before use.
110
Check the suction filter is clean.
• Inspect the machine to ensure there is
no damage or wear which could lead
to injury, further damage or reduced
performance
• Check all plumbing lines & fittings to
ensure they are tight, not damaged or
leaking
• Check to ensure frost and/or vermin
have not damaged the machine
• Check the suction filter is clean
• Check the pressure filter is clean
• Check nozzles are spraying correctly
• Check all hydraulic connections
• Check boom controls functions
• Check all spraying control functions
(refer to the instructions in this manual)
Be sure to adequately clean and flush all chemical handling
equipment.
All spray equipment should be cleaned at the start and
end of each spray season including all filters and nozzles.
Check tyre inflation and wheel nuts.
• Check tyres are correctly inflated
• Check all lights are working correctly
• Check all bolts & nuts are tight &
secure
• Ensure there is a sufficient clean water
in the hand wash tank for personal
hygiene and chemical safety
• Organise communication with
someone to come to your aid, if
required.
A more comprehesive checklist of routine
checks is provided in chapter 8, 'Lubrication &
Maintenance'.
Test the pump with clean water. Switch on the pump at the
lowest revolutions possible & gradually increase revolutions
until the pump reaches its operating speed.
Do not exceed 4200 rpm on centrifugal pump or 540 rpm
on diaphragm pump.
Engage the batter isolator switch to provide power to the
Cruiser systems.
Starting the Cruiser
Before starting the Cruiser, the battery isolator
switch must be engaged to provide power to
the machine systems.
To start the engine, the transmission must
be in neutral. Insert the ignition key and turn
clockwise (the ignition key is located on the
rear right console).
After starting the Cruiser, allow hydraulic oil to
warm up before operating hydraulic functions.
Before Starting in Cold Conditions
If the Cruiser in a cold environment, always
check components to make sure that they
have not been damaged and that there is no
ice in the system before starting spraying.
If the water has frozen in the pump and/or in
the lines, wait until it has completely thawed
before use.
The operator must wear the operator safety belt at all
times when seated in the cabin or when the machine is
in motion.
GA8701177 REV 2 APRIL 2022