Two 12 volt supply batteries located under the chassis.
Electrical System
Batteries
The electrical system operates on 12 volts. To
provide a 12 volt supply with sufficient current,
two 12 volt batteries are used in parallel.
•
Before carrying out any repairs to the
electrical system turn the Battery Isolator
switch to the 'Off' position.
The battery isolator is located just behind
the fuel tank on the right hand side.
•
When welding, connect the ground
terminal directly to the part being
welded and ensure that the batteries are
disconnected.
Disconnect any electronic controls such
as the engine controller, transmission
controller, G-hub controllers, PLC, RCM,
etc.
•
When welding on the machine ensure, if
fitted, that all weed seeker controllers are
totally removed from the machine.
GA8701177 REV 2 APRIL 2022
The Battery Isolator located on the right hand side of the
engine.
Battery Isolator
The battery isolator is located just behind the
fuel tank on the right hand side.
The battery isolator switches power flow from
the batteries to the machine.
The isolator switch is a 250 Amp unit which
cuts all power to the machine except for the
radio back up power.
The isolator switch must be isolated when
the machine is not in use to prevent battery
leakage or power faults.
The Battery Isolator switch does NOT function as an
emergency engine stop.
Shut down the engine using the On/Off Ignition key in the
cabin.
The isolator key should only be removed after more than
30 seconds from stopping the engine - so that there is
sufficient time for data to be written & saved to the ECU.
Integrated Systems – Appendix
Auxiliary power connection points located on the left hand
side of the machine.
Chassis Auxiliary Power Points
General
Auxiliary power connection points (12V, 30A
maximum) are fitted to the side of the left hand
pod.
They can be used as a battery charging point
or to power electrical attachments, but NOT
to be used for jump starting.
Switched/fused power stud located under the front axle.
Four ground/connection points located on the chassis
Lighting
A switched and fused power stud (12V, 500W
maximum) is provided for customer fitted
lighting accessories under the front axle area
just under the hydraulic manifold.
Chassis Ground Points
There are four ground points located on the
chassis to assist with connection of optional
equipment.
10
239