Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 88

Preparation for Use – Setting Up
4 4
Press the Fill Pump Raise 'Auto' touch button to select or deselect the function,
then press the 'Engine RPM' display touch button to set the speed.
iii) Spray Pump RPM
The Spray Pump RPM setting sets an engine speed to be
automatically activated when the Spray Pump is activated and
the Cruiser is stationary.
To Select the Spray Pump RPM:
Press the Spray Pump RPM 'Auto' touch button to select
or deselect it.
The touch button displays Green when selected & Grey
when deselected.
To Set the Spray Pump RPM:
1 Press the Spray Pump RPM 'Engine RPM' display
touch button and a numerical keypad appears.
2 Press the numbers to set the required value, (eg, 1500),
then press 'Enter'. The screen returns to the RPM
tab screen with '1500' displayed in the 'Engine RPM'
display.
88
Press the 'SAVE' touch button to save your settings.
The Engine RPM screen is the last screen of the pre-setting
procedures of the G-Hub. It is important to press the 'SAVE'
touch button (on the left hand side of the screen) to save the
entered pre-set values into the G-Hub system.
The 'SAVE' touch button will appear on the left hand side of the screen if a new
value is entered or a change made in the G-Hub system.
If the 'SAVE' touch button is not pressed, then any current changes or entered
value or values will be lost and previous settings will remain.
The 'SAVE' touch button can be pressed at any stage or screen change to
ensure new settings are saved and not accidentally lost.
The screen will return to the G-Hub home screen after the 'SAVE' touch button
is pressed.
GA8701177 REV 2 APRIL 2022