Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 85

Press the Headland Speed (kph) display touch button to set the headland speed.
i) Headland Speed (kph)
The Headland Speed (kph) setting is used to set the Headland
travel speed which is the lower speed to which the Cruiser
will slow down when the variable speed or two speed cruise
function is activated. The upper cruise limit is set via the
joystick cruise set buttom
To Set the Headland Speed (kph):
1 Press the 'Headland Speed (kph)' display touch button
and a numerical keypad appears.
2 Press the numbers to set the required value (eg, 10),
then press Enter. The screen returns to the Cruise tab
screen with eg, '10' displayed in the 'Headland Speed
(kph)' display.
The Headland Speed must be set lower than the maximum or top cruise speed.
A setting between 8 and 15 kph is recommended.
GA8701177 REV 2 APRIL 2022
Press the 'Accel Rate (sec)' display touch button to set the rate of acceleration.
ii) Accel Rate (sec)
The Accel Rate (sec) touch button determines the acceleration
rate used for the Cruiser to reach its higher speed target when
changing up gears. Enter a value from 1 to 5. The higher the
number, the more aggressive is the acceleration.
To Set the Accel Rate (sec):
1 Press the 'Accel Rate (sec)' display touch button and a
numerical keypad appears.
2 Press the numbers to set the required value, (eg, 1),
then press Enter. The screen returns to the Cruise
tab screen with '1' displayed in the 'Accel Rate (sec)'
display.
The recommended Accel Rate setting is 1.
The recommended Decel Rate setting is 1.
Setting Up – Preparation for Use
Press the 'Decel Rate (sec)' display touch button to set the rate of deceleration.
iii) Decel Rate (sec)
The Decel Rate (sec) touch button determines the the
deceleration rate used for the Cruiser to reach its lower speed
target when changing down gears. Enter a value from 1 to 5.
The higher the number, the more aggressive is the deceleration.
To Set the Decel Rate (sec):
1 Press the 'Decel Rate (sec)' display touch button and a
numerical keypad appears.
2 Press the numbers to set the required value, (eg, 1),
then press Enter. The screen returns to the Cruise
tab screen with '1' displayed in the 'Decel Rate (sec)'
display.
The 'SAVE' touch button will appear on the left hand side of the screen if a new
value is entered or a change made in the G-Hub system.
If the 'SAVE' touch button is not pressed, then any current changes or entered
value or values will be lost and previous settings will remain.
The 'SAVE' touch button can be pressed at any stage or screen change to
ensure new settings are saved and not accidentally lost.
The screen will return to the G-Hub home screen after the 'SAVE' touch button
is pressed.
4
85