Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 222

Fast Tracking Problems – Trouble Shooting
9
The External Controller.
To Check the Function of Each Push Button:
1 While in the External Diagnostic screen, press the relevant
touch button on the External Controller:
• If a push button is working, its corresponding switch
on the External Diagnostic screen will light up Green or
Blue each time the push button is pressed.
• If a push button is not working, its corresponding touch
button on the Console Diagnostic screen will not light
up.
2 If a push button on the External Diagnostic screen does not
light up, then locate the External Display Module (shown
above right) and check that connectors are fitting correctly.
Checking Switch functions on the External Display requires 2 persons, one in the
cabin observing the External Display Diagnostic screen and one outside operating
the External Display.
222
The External Controller is part of the Chassis Controller or Main PLC located
inside the left hand side Fill Area toolbox.
3 The External Display Module is located in the left hand side
Fill Area toolbox. Open the door of the toolbox and check
the connectors.
4 After checking the External Display Module connectors,
re-check the function of the relevant External Display push
buttons and the External Diagnostic screen touch buttons.
5 If a function continues to not light up it may be neccessary
check the relevant function in Virtual Mode.
(A)
Press the Virtual Mode touch button (A) to engage Virtual Mode, then press the
relevant push buttons to test their function.
To Check Functions in Virtual Mode:
1 Press the Virtual Mode touch button to engage/disengage
the Virtual Mode.
The touch button displays Green when engaged & Grey
when disgaged.
2 Press the relevant Fill touch buttons (on the right hand side
of the screen) to test its function.
If working, the item will operate while the touch button is On
and stop when the touch button is Off.
3 When testing is completed, press the Virtual Mode touch
button to disengage Virtual Mode.
The touch button displays Grey when disgaged & Green
when engaged.
Only 'Fill' screen functions can be operated or checked in Virtual Mode.
'Clean' screen functions cannot be checked or operated in Virtual Mode.
GA8701177 REV 2 APRIL 2022