Cruise Resume/Increase; Cruise Cancel; Transmission Shifter; Monitor Display - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Press the upper Cruise Set/Increase push button to resume
current ground speed for Cruise Control & once set, press
the push button again to increase the set ground speed.

Cruise Resume/Increase

The Cruise Resume/Increase push button
is used to resume the previosly set current
ground speed as the Cruise Control and
increase the set ground speed.
To Resume/Increase Cruise Control Speed:
i) Press the Cruise Resume/Increase push
button to resume the previously set ground
speed as the Cruise Control Speed.
ii) Once the Cruise Control Speed is set/
engaged, press the Cruise Resume/
Increase push button down to increase the
set ground speed.
To disable Cruise Control, press the Cruise
Cancel push button or apply the Foot Brake
which also cancels the Cruise Control.
GA8701177 REV 2 APRIL 2022
Press the Cruize Cancel switch on the on the Joystick to
cancel the cruise control function. Press again to reactivate
the cruise control.

Cruise Cancel

The yellow Cruise Cancel push button is used
to cancel the active Cruise Control. Applying
the Foot Brake also cancels the Cruise
Control.
The Cruise Master switch is also used to cycle
the Cruise Control between On [active] and Off
[inactive].
Operation – Ready to Spray

Transmission Shifter.

Transmission Shifter
To Engage a Gear & Drive:
i) Check the display shows N (Neutral). If
not select Neutral by pressing the N push
button.
ii) Apply the foot service brake located to the
right of the steering column
iii) Release the Park Brake.
iv) Press the 'D' push button to drive forward
or the 'R' push button to reverse.
To Stop Driving & Disengage Gears:
i) Apply the foot service brake located at
near base (right) of the steering column.
ii) Pressing the 'N' push button to place the
unit in Neutral (all gears deactivated).
iii) Apply the Park Brake.
An alarm sounds & a warning illuminates, if the
transmission is moved into a gear other than Neutral when
the Park Brake is engaged.
Select & Monitor displays showing Neutral.

Monitor Display

The Monitor Display allows the operator to
glance down & quickly observe which gear is
being used.
Select Display (left side)
In the Select Display, a single LED character
shows the gear selected by the operator. It will
display D, R, or N or Gear Number of the gear
selected.
Monitor Display (right side)
In the Monitor Display, a single LED character
shows which transmission gear is currently
engaged. This includes R, N, and Gear
Number of the forward gear but not D (Drive).
Select & Monitor displays showing Reverse gear.
6
119