Spraying System Touch Buttons - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Spraying System Touch Buttons

The Spraying System touch buttons (shown above) provides 7
button functions along the top the screen:
• Tank Fill
• Tank Rinse
• Filter Clean
• Agitator
• Rapid Flow
• Pump
• RPM Raise.
All touch buttons show Grey when Off, Amber in Auto and
Green when On
16 On/Off Boom touch buttons at the base of the screen (one
for each boom section) show Amber when Off and Green when
On (active).
The FL & FR Fencline symbols are used for display only.
The Boom Section touch buttons & Fencline indicators display:
- Green when On
- Amber when Waiting
- Clear when Off.
GA8701177 REV 2 APRIL 2022
Tank Fill Touch Button
Press the Tank Fill touch button (shown above) and drop a
down menu of three touch buttons appears:
• Custom - allows the operator to set the Product Tank fill
volume (litres) before filling.
1 Press the 'Custom' touch button and a keypad
appears.
2 Press the touch buttons to enter the amount of Fill
liquid required for the Product Tank, then press Enter.
The screen returns to the 'Tank Fill' touch button
(Orange). The 'Desired Fill' is now set for use on the
External Display.
• Density factor - allows the operator to change the
density factor according to chemicals being used.
1 Press the 'Density Factor' touch button and a
keypad appears.
2 Press the touch buttons to enter the Density Factor
required (1000 = 1.0 unit), then press Enter.
The screen returns to the 'Tank Fill' touch button.
• Off
Press the 'Off' touch button & the screen returns to the
'Tank Fill' touch button 'Off' (grey).
Cabin – Your Sprayer at a Glance
Tank Rinse Touch Button
Press the Tank Rinse touch button (shown above) and drop
down menu of two touch buttons appears:
• On
Press the 'On' touch button & the screen returns with
the 'Tank Rinse' touch button displaying 'On' (Green)
• Off
Press the 'Off' touch button & the screen returns with
the 'Tank Rinse' touch button displaying 'Off' (Grey).
The Density Factor under the Tank Fill touch button resets to 1.0 on system
reboot.
Reset the Density Factor to the desire setting after a system reboot.
3
51