Goldacres G6 Crop Cruiser 2 Series Operator's Manual page 138

Ready to Spray – Operation
6
Open the hopper lid to access the Drum Rinse Nozzle.
4 Open the Hopper lid to access the Drum
Rinse Nozzle.
5 Press the 'Fill Pump' push button On.
If filling the Main Product tank at the same
time and more pressure is required at the
drum rinse, press & hold the Fill Product
push button for 2 seconds.
6 Place the opening of the chemical drum
over & onto the Drum Rinse Nozzle inside
the hopper.
7 Press the drum down on the Drum Rinse
Nozzle to engage the rinsing function.
Press the 'Fill Pump' push button On.
138
Press the 'Fill Pump' push button Off.
8 When the drum rinsing is complete, lift &
remove the drum from the Drum Rinse
Nozzle.
9 Press the 'Fill Pump' push button Off.
10 Empty the Hopper rinse by:
• Emptying the Hopper to the Product
Tank, or
• Draining the Hopper via the Bottom
Drain valve.
Connect a 3" fill hose to the 'Clean Fill' inlet & Open the
'Clean Fill' ball valves.
To Rinse the Chemical Induction
b)
Hopper
1 Connect a 3" suction hose (not supplied)
to the 'Clean Fill' camlock coupling with
the other end connected to a clean water
source.
2 Open the 'Clean Fill' ball valve by moving
the handle down.
3 Close & lock down the Hopper lid.
Close & lock down the hopper lid.
Ensure the 'Pump Product' push button is On, then press
the 'Fill Pump' & 'Rinse Nozzle' push buttons On.
4 Ensure the 'Pump Product' push button is
On.
5 Press the 'Fill Pump' & 'Rinse Nozzle'
push buttons On.
6 Open the Rinse Valve on the top of the
hopper.
7 Empty the rinse liquid from the hopper by:
• Transfering contents of the Hopper to
the Product Tank, or
• Emptying the Hopper via the Bottom
Drain valve.
Open the Rinse Valve on top of the hopper lid.
GA8701177 REV 2 APRIL 2022