Quick Start Guide; Starting-Up; Driving - Goldacres G6 Crop Cruiser 2 Series Operator's Manual

Ready to Spray – Operation
6
Engage the Battery Isolator switch.

Quick Start Guide

It is the responsibility of the operator to
familiarise themselves with and understand
the information in this manual to ensure
competent and safe operation.
Follow the Quick Start instructions to start the
engine, drive and shut-down the Cruiser.

Starting-Up

1 Perform a pre-operation check of the
Cruiser.
2 Engage the Battery Isolator (located on the
right hand side chassis by the engine).
Before starting the engine:
• All fluid levels must be checked.
• Ensure the battery isolator switch is engaged - to
provide power to the sprayer systems.
• Ensure the transmission in neutral. Otherwise the
engine will not start.
112
Turn the Ignition key to On/Acessories
3 Turn the Ignition key to On/Acessories
(lightning symbol)
4 Check Park Brake switch is ON.
Engage the Park Brake - slide back the orange lock &
press the switch forward (On position).
Turn the Ignition key to crank & start the engine.
5 Turn & hold the Ignition Key momentarily in
crank position until engine starts.
The operator & any passenger must be seated in the cabin
and wearing the seat safety belt at all times when the
machine is in motion.
For more detailed information on the Transmission Shifter
refer to pages 47-49 of Chapter 3.
Disengage the Park Brake - slide back the orange lock, then
press the switch rearward (Off postion).

Driving

1 Run engine for least 30 seconds to allow
the compressor to build the required
system air pressure.
2 Check the Foot Brake for response, then
hold the Foot Brake down.
3 Disengage Park Brake.
4 Press the 'D' switch to engage Forward
drive or the 'R' switch to engage Reverse.
5 Use the steering wheel, foot accelerator &
foot brake to drive safely.
Press the 'D' switch to engage 1st gear. 1-6. Press the
Arrow switches to change Up or Down (gears 1-6).
GA8701177 REV 2 APRIL 2022