User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
no remotecon timeout
This command sets the remote connection session timeout value, in minutes, to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default 5
Format
Mode
serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default
Format
Mode
no serial baudrate
This command sets the communication rate of the terminal interface to 9600.
Format
Mode
serial timeout
This command specifies the maximum connect time (in minutes) without console activity. A value
of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.
Default
Format
Mode
no serial timeout
This command sets the maximum connect time (in minutes) without console activity to 5.
Switching Commands
no remotecon timeout
Privileged EXEC
9600
serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 |
38400 | 57600 | 115200}
Line Config
no serial baudrate
Line Config
5
serial timeout <0 - 160>
Line Config
202-10009-01_060204
8-21