Spanning-Tree Guard; Spanning-Tree Max-Age - NETGEAR ProSafe GSM7228PS Cli Manual

no spanning-tree forward-time
This command sets the Bridge Forward Delay parameter for the common and internal spanning
tree to the default value.
Format
no spanning-tree forward-time
Mode Global Config

spanning-tree guard

This command selects whether loop guard or root guard is enabled on an interface. If neither is
enabled, then the port operates in accordance with the multiple spanning tree protocol.
Default none
Format
spanning-tree guard { none | root | loop }
Mode Interface Config
no spanning-tree guard
This command disables loop guard or root guard on the interface.
Format
no spanning-tree guard
Mode Interface Config

spanning-tree max-age

This command sets the Bridge Max Age parameter to a new value for the common and internal
spanning tree. The max-age value is in seconds within a range of 6 to 40, with the value being less
than or equal to 2 x (Bridge Forward Delay - 1).
Default 20
Format
spanning-tree max-age <6-40>
Mode Global Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-15