Hardware-Address; No Hardware-Address; Host; No Host - NETGEAR ProSafe GSM7224 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

hardware-address

This command specifies the hardware address of a DHCP client.
Hardware-address is the MAC address of the hardware platform of the client consisting of 6 bytes
in dotted hexadecimal format.
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
Default
Format
Mode

no hardware-address

This command removes the hardware address of the DHCP client.
Format
Mode

host

This command specifies the IP address and network mask for a manual binding to a DHCP client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
The prefix-length is an integer from 0 to 32
Default
Format
Mode

no host

This command removes the IP address of the DHCP client.
Format
Mode
DHCP Server Commands
Ethernet
hardware-address <hardwareaddress> [type]
DHCP Pool Config Mode
no hardware-address
DHCP Pool Config Mode
None
host <address> [mask | prefix-length]
DHCP Pool Config Mode
no host
DHCP Pool Config Mode
202-10009-01_060204
9-3