Issue No. 1.5
12 - 24
4.2.1
Connecting the Interface Unit
1.
Set DSW1 to the pattern for the applicable multiline terminal as
shown in
2.
Place the ADM and multiline terminal upside down and remove
the Base Units.
Series
term
D
Series i
3.
Plug the interface unit into the right adapter connection as
shown on
Covers Removed
Figure 12-31 ADM and Multiline Terminal with Base Covers Removed
4.
Place the interface unit cable in the cable channels on the ADM
and multiline terminal.
5.
Install the connector plate provided with the ADM as shown in
Figure 12-32 Installing the Connector Plate
Table 12-4 DSW1 Switch Positions
Table 12-4 DSW1 Switch Positions
Multiline Terminal
DTR/H-(8)/(16)D-2( ) TEL
DTR/H -16LD-2( ) TEL
DTR/H-16D(BL)-2( ) TEL
Figure 12-31 ADM and Multiline Terminal with Base
on the next page.
Installing D
UNIVERGE SV8100/SV8300
on the next page.
DSW1 Switch Positions
ON
1 2 3 4 5 6 7 8
on the next page.
term
Series i Optional Equipment