Installation; Figure 10-46 In-Line Power Adapter Switch Settings - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
10 - 58
The ILPA-R( ) adapter is intended for use with IP phones and IP
Adapters. Installing any other device into the telephone port of the
ILPA-R( ) may result in damage to the device.
When powering an IP phone using an ILPA-R( ) adapter, the
phone should not get connected to a port on the Router Blade.
When using center feed, set the SW1 switch located on the back of
the adapter as follows:

Figure 10-46 In-Line Power Adapter Switch Settings

12.2.2

Installation

1. Set the SW1 switch on the ILPA-R( ) adapter to the correct
setting for the ethernet switch to which it is to be connected.
2. Set the switch setting on the NEC IPhone or IP adapter to the
correct position.
UNIVERGE SV8100/SV8300
Center Feed Hub System
IEEE802.3af STD System
Cisco Discovery Protocol System
NEC BlueFire 200/24 Switch
Center Feed Hub System
IEEE802.3af STD System
Cisco Discovery Protocol System
NEC BlueFire 200/24 Switch
IPhone (SW2) or IP Adapter (SW1)
NEC Power Patch Panel
(12 port NEC SN1604 PWRMS,
24 port NEC BlueFire 200/24)
8SHUBU Blade
Cisco Catalyst Power Patch Panel
Cisco Catalyst PRW Series
Installing SV8100/SV8300 Optional Equipment
SW1 Setting
1
1
2
SW1 Setting
1
1
2
SW Setting
1
2