Figure 12-2 Removing The Multiline Terminal Base Plate; Figure 12-3 Modifying Base Plate For Adapter Installation - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
3.
4.
12 - 2
Press down on the tabs indicated in
Base Plate, and push forward on the base plate to remove it.

Figure 12-2 Removing the Multiline Terminal Base Plate

When an adapter is installed for the first time, the base cover on the multiline
terminal must be modified. Two adapters can be installed in the multiline terminal,
and two separate cutouts are provided. Remove the applicable cutout/cutouts on
the bottom of the base plate. When only one adapter is being installed and it
needs an AC-2R/AC-3R Unit for power, remove only the right cutout as shown in
Figure 12-3 Modifying Base Plate for Adapter

Figure 12-3 Modifying Base Plate for Adapter Installation

UNIVERGE SV8100/SV8300
Figure 12-2 Removing the Multiline Terminal
Installation.
Remove for Cable
Connector
term
Installing D Series i Optional Equipment
Remove for AC
Adapter Plug
Remove for Adapter