Order Of Installing Extension Blades; Table 6-1 Extension Blade Installation Order Example - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
6 - 4
2.2.2

Order of Installing Extension Blades

The order in which the station blades (
CD-16DLCA
physically inserted determines the numbering plan.
For example, when a digital station blade (CD-16DLCA) is in Slot 1
(ext. 101~116) and three additional digital station blades are installed
in the following order, the numbering plan below in
Extension Blade Installation Order Example on page 6-4

Table 6-1 Extension Blade Installation Order Example

Order of
Installation
1
2
3
4
After the initial powering up of the system, subsequent powering up or
reset does not change the slot identification. System programming
(Program 90-05) must be performed to change the slot identification.
Adding any daughter board to increase the available ports or going to
a higher capacity blade (e.g., CD-16DLCA) may require that the slot
be deleted in programming and the blade reinstalled. In the following
example, to add a daughter board to slot 2, the blade must be
removed, deleted in Program 90-05-01, then reinstalled with the
daughter board attached, otherwise the additional ports are not
recognized. This however, uses new ports for the combined blade –
the initial ports (ports 17~24 using the example below) are not used.
, and
PZ-8DLCB CD-4LCA
To avoid unexpected extension/trunk numbering if
the VoIP or Voice Mail blades register with the
system first, install these blades after the other
types of extension and trunk blades have been
installed.
Blade Slot
Number
1 CD-16DLCA
2 CD-16DLCA
4 CD-8DLCA
PZ-8LCE
3 CD-8DLCA
Installing the SV8100/SV8300 Blades
UNIVERGE SV8100/SV8300
,
CD-8DLCA
, ,
CD-8LCA PZ-8LCE
Table 6-1
applies.
Extension
Blade
Numbers
101~116
117~132
133~148
149~156
) are