Figure 4-21 Install Additional Chs2U Joint Bracket Kit - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
3. Metal brackets from the CHS2U JOINT BRACKET KITs will be
required to secure the top end of the chassis with screws. See
Figure 4-21 Install Additional CHS2U JOINT BRACKET

Figure 4-21 Install Additional CHS2U JOINT BRACKET KIT

4. Using supplied screws, secure the CHS2U STAND KIT to the
floor (refer to Figure 4-21 Install Additional CHS2U JOINT
BRACKET KIT).
To prevent possible damage to the 19" chassis due to
falling, NEC recommends screws be installed in the
stand mount brackets as soon as possible.
5. Connect the ground wire to all chassis. Refer to
Chassis Grounding on page 4-34
grounding the system.
6. Refer to 3.5 Installing the 19" Chassis on page 4-24
installation of the chassis or, Chapter 5 paragraph
an Extension or Trunk Blade on page 6-3
blades.
Issue No. 1.5
Metal
Brackets
3.5.5 Install 19"
for complete details on
to continue
2.2 Installing
for installation of
KIT.
4 - 21