UNIVERGE SV8100/SV8300
System Hardware Manual
Supports Red and Green LED colors
5.2.1.1 Installing the 8LK-L UNIT
1.
Remove both plastic panels from the front of the
multiline terminal.
2.
Turn multiline terminal upside down.
Only one 8LK-L UNIT can be attached to the DTL/ITL
multiline terminal.
3.
Pry the side panel from the multiline terminal.
Side Panel
Figure 7-51 Remove Side Panel from Multiline Terminal
4.
Return the multiline terminal to the buttons side up
position.
5.
Fit the projections on the side of the 8LK-L UNIT into
the guide holes on the side of the multiline terminal.
Figure 7-50 8LK-L UNIT
To prevent possible damage to the 8LK-L
UNIT or the DTL/ITL multiline terminal
during installation or removal,
disconnect the line cord/LAN cable and
the AC/DC adapter from the DTL/ITL
multiline terminal.
Issue No. 1.5
7 - 45