Remove And Install Cooling Fan; Chs1U-Au Chassis; Remove Cooling Fan; Figure 5-105 Installing Cover Battery - NEC UNIVERGE SV8100 System Hardware Manual

Hide thumbs Also See for UNIVERGE SV8100:

Table of Contents

Issue No. 1.5

If required, the cooling fan installed in the CHS1U-AU and the CHS2U-AU chassis can

be removed and replaced. The following provide separate procedures for both types of

Insert tabs on cover into holes on CHS LARGE BATT BOX. Slide

the cover left until seated and tighten the screw. Refer to

5-105 Installing Cover

Ensure the chassis is powered down.

To reduce the possibility of electrical shock or

damage to equipment, NEC recommends

powering Off the chassis and disconnecting the

AC cable from the power source before

removing the chassis cover.

To reduce the possibility of damage to

equipment, the installer must wear a

grounded wrist strap to protect the

equipment from static electricity.

UNIVERGE SV8100/SV8300

Installing the SV8300 Chassis

Show Quick Links

Table of Contents

Univerge sv8300