Battery Connection; Installing The Internal Batteries; Figure 4-47 Removing Battery Access Panel - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
B
S 4
ATTERY
ECTION
There are two types of battery connection to provide battery life in the event of a power
failure, the internal battery and an external battery with CHS LARGE BATT BOX.
4.1
System Hardware Manual
C
ONNECTION

Installing the Internal Batteries

An internal battery source using two batteries can be installed using the CHS2U
BATT MTG KIT (mounting kit) and CHS2U BATT CA INT (internal cabling).
CHS2U BATT MTG KIT (Backup time = 10 Minutes/24 Terminals)
1. Power down the CHS2U-AU chassis.
Ensure the CHS2U-AU chassis is powered OFF.
2. Disconnect AC power and grounding cable from rear of chassis.
3. Remove screws from battery access panel on rear of chassis. Refer to
Figure 4-47 Removing Battery Access

Figure 4-47 Removing Battery Access Panel

Issue No. 1.5
Panel.
4 - 37