Issue No. 1.5
5 - 18
4.
Install the five rubber feet to the bottom of the chassis.
Figure 5-16 Install Rubber Feet (19" Chassis)
5.
Position the CHS1U-AU and CHS2U-AU chassis on top of the
CHS BASE UNIT.
6.
Secure the chassis to the CHS BASE UNIT using screws
supplied with the CHS STAND KIT (K).
Figure 5-17 Install CHS2U JOINT BRACKET KIT
7.
Connect the ground wire to all chassis. Refer to
Chassis Grounding on page 5-45
grounding the system.
8.
Refer to
3.5 Installing the 19" Chassis on page 5-33
installation of the chassis or, Chapter 5 paragraph
an Extension or Trunk Blade on page 6-3
blades.
UNIVERGE SV8100/SV8300
3.5.7 Install 19"
for complete details on
to continue
2.2 Installing
for installation of
Installing the SV8300 Chassis