Figure 4-24 Rack Mount 19" Chs2U-Au - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
Repeat for additional chassis mounting.
Figure 4-23 Rack Mount Bracket Installed 19" CHS2U-AU
4. Carefully slide the chassis into desired location within the rack. Make
sure the hooks on the mounting bracket are inserted into the back of the
chassis, securing it in place. Note that the cabling is run through the front
of the rack for ease of access.
Each CHS2U-AU chassis will require
approximately 3.5" of height within the rack.
5. Secure the brackets to the rack using the screws supplied.
Repeat for additional chassis mounting.
Single Rack Mount
CHS2U-AU

Figure 4-24 Rack Mount 19" CHS2U-AU

6. Connect the ground wire to all chassis. Refer to
Grounding on page 4-34
Single
CHS2U-AU
with Three Expansion Chassis
for complete details on grounding the system.
Issue No. 1.5
Rack Mount
3.5.5 Install 19" Chassis
4 - 23