Installing An Extension Or Trunk Blade; Installing The Blades; Figure 6-2 Inserting Blades In The 19" Chs2U-Au Chassis - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
2.2
System Hardware Manual
Use caution when installing or modifying telephone lines.
Ground the Controlling and Expansion chassis before installing or
removing the blades.
The Expansion Chassis must be installed with the system power OFF.
Do not touch the blade components.
Carry the blade in a conductive polyethylene bag to prevent static
electricity until ready to install the blade.
When installing or removing the blades from the chassis, the installer
must wear a grounded wrist strap to protect the blade from static
electricity.
Although it is recommended to install the blades with the system power
OFF, most blades can be installed hot except for the following that must
be installed with the power OFF:
CD-CP00-AU
CC-CP00
PZ-BS10 and PZ-BS11
PZ-ME50-AU
PZ-32IPLA, PZ-64IPLA and PZ-128IPLA
PZ-VM21

Installing an Extension or Trunk Blade

2.2.1

Installing the Blades

To install an extension/trunk blade with the system running:
1. Insert the blade within the guide rail and push the blade securely
into position. Tighten the thumb screw on either side of the
blade.
2. The Status LED starts flashing when the blade starts processing
(15 seconds).

Figure 6-2 Inserting Blades in the 19" CHS2U-AU Chassis

Issue No. 1.5
6 - 3