Stand Mounting The 19" Chassis; Chs1U-Au+Chs2U-Aux1 Chassis Installation; Figure 5-20 Stand Mount Spacing Guide (Chs1U-Au+Chs2U-Aux1 Chassis Installation) - NEC UNIVERGE SV8100 System Hardware Manual

Hide thumbs Also See for UNIVERGE SV8100:

Table of Contents

Issue No. 1.5

Stand Mounting the 19" Chassis

The SV8300 can be stand mounted. Controlling and Expansion chassis can be

stand mounted using the CHS STAND KIT (K), the CHS2U STAND KIT (EXT)

and the CHS2U JOINT BRACKET KIT.

Using the spacing guide shown below, mark two holes to be

drilled. Refer to

(CHS1U-AU+CHS2U-AUx1 Chassis Installation) on page 5-20

for required spacing before drilling.

Figure 5-20 Stand Mount Spacing Guide (CHS1U-AU+CHS2U-AUx1

Drill the two holes required for a floor installation.

UNIVERGE SV8100/SV8300

Figure 5-20 Stand Mount Spacing Guide

It is suggested that plywood first be installed on the

floor where the chassis will be positioned. This allows

for secure anchoring of the screws which will be

supporting the weight of the chassis.

For Stand Mount, up to three

CCHS2U-AU chassis can stand with a

CHS1U-AU chassis.

Chassis Installation)

Installing the SV8300 Chassis

Show Quick Links

Table of Contents

Univerge sv8300