Mounting On The Basic Processing Unit - NEC N8151-34A User Manual

Mounting on the basic processing unit

Turn off the power before installing or removing the device
Always be sure to turn off the main power and unplug the power cord from
the AC outlet before installing/removing this device or connecting any cables.
There is a risk of electric shock if this device in installed or removed or if any
cables are connected while the power cord is still plugged into an AC outlet.
The procedure for installing the drive in a server is as follows.
Hint
Some servers require the rails to be used. For details on how to install the rails, refer to the
server's operating manual.
1
Install the N8151-34AF Built-In AIT as
shown here.
Important
• When using the rails, adjust
their mounting positions so
that the front cover of this
device is aligned with the front
covers of the other standard
components (such as the CD-
ROM).
• The screws needed with the
5.25-in and 3.5-in devices are
the same.
• Always use the screws that are provided with this device. The screws
that are provided with this device are metric screws (length: 5.0 mm;
length below washer: 3.5 mm). Using screws that are longer than the
screws that are provided with this device could result in damage to the
device.
80 Built-in AIT
Caution
Use screws to secure
the upper rail.
Front cover
Rails
3.5 mm
metric screw