Figure 7-33 Removing Numbered Keypad From Dt300/Dt700 Series Terminal; Figure 7-34 Install New Numbered Keypad Into Dt300/Dt700 Series Terminal - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
2. Pull down on the tab and lift the Numbered Keypad away from
the telephone to remove the existing button. Refer to
Removing Numbered Keypad from DT300/DT700 Series
Terminal.
Figure 7-33 Removing Numbered Keypad from DT300/DT700
3. Slide the replacement numbered keypad into the grooves
located on the inside of the telephone, then press down on the
keypad to snap it into place. Refer to
Numbered Keypad into DT300/DT700 Series
Figure 7-34 Install New Numbered Keypad into DT300/DT700 Series
Series Terminal
Figure 7-34 Install New
Terminal.
Terminal
Issue No. 1.5
Figure 7-33
7 - 33